| |
SEAGATE TECHNOLOGY LLC
1-800-SEAGATE
http://www.seagate.com
(C)opyright 2006
ST-3400633AS (Barracuda 7200.9 400, Serial ATA NCQ)
ÉÍÍÍÍÍÍÍÍÍÍÍ»
º REAR VIEW º
ÈÍÍÍÍÍÍÍÍÍÍͼ
ÚÄÄTop (HDA)ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ~~~ÄÄÄÄÄÄ¿
³ ³
³ ³
³ ________ ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ/ \ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ~~~ÄÄÄÄÄÄÙ
ÍÍÍÚÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÌÍÍÚÑÑÑÑÑÑÑÌÍÍ͵ú ú ú úÆÍÍÍÍÍ~~~ÍÍÍÍÍÍÍ
Ó 1Ó Ó 1Ó ³ ³ ÀÂÙ
³ ³ ³ ³ ÀÄ Limit external transfer
³ ³ ³ ³ rate to 1.5 Gbits/sec
³ ³ ÀÄÁÄÄÄÄ Reserved
³ ³
³ ÀÄÄ Signal connector (7 pins)
ÀÄÄÄÄÄÄÄÄÄÄÄ Power Connector (15 pins)
ST-3400633AS
Barracuda 7200.9
FORMATTED CAPACITY (GB) __________________400
ACTUATOR TYPE ____________________________VOICE COIL
MEDIA TYPE _______________________________THIN FILM
HEAD TYPE ________________________________GMR
RECORDING METHOD _________________________EPRML 16/17 ZBR
INTERNAL TRANSFER RATE (Mbits/sec) _______up to 815.2
SUSTAINED TRANSFER RATE (Mbytes/sec)______up to 65.0
EXTERNAL TRANSFER RATE (Mbytes/sec) ______up to 300
PIO/DMA/UDMA MODE (max) __________________4/2/5
SPINDLE SPEED (RPM) ______________________7200
AVERAGE LATENCY (mSEC) ___________________4.16
BUFFER ___________________________________16MB
Read/Write Multiple, Read Look-Ahead,
Multi-Segmented
INTERFACE ________________________________SATA 2.0 w/NCQ
SECTORS PER DRIVE (LBA mode) _____________781,422,768
KTPI (KTRACKS PER INCH Avg) ______________124.5
BPI (KBITS PER INCH) _____________________up to 790.1
AVERAGE ACCESS (ms seek/read/write) ______/<8.2/<9.0
SINGLE TRACK SEEK (ms seek/read/write) ___/<0.8/<1.0
MAX FULL SEEK (ms seek/read/write) _______//
ANNUALIZED FAILURE RATE (AFR) ____________0.34%
SHOCK (G's, 11ms/2ms):
operating (Read/Write) __________/63
abnormal ________________________
nonoperating ____________________/350
ACOUSTICS (bels)
fluid bearing (typ/max-quiet/max-perf) _2.8/3.9/
POWER DISSIPATION (watts) ________________
POWER REQUIREMENTS: +12V START-UP (amps) _2.90
POWER MANAGEMENT (Watts):
ACTIVE _______________13.00
IDLE _________________9.30
STANDBY (typ/max) ____1.25/
Physical:
Height (inches/mm): 1.028/26.1
Width (inches/mm): 4.00/101.6
Depth (inches/mm): 5.78/146.99
Weight (lb/g): 1.57/710
Set CMOS hard drive setup to Auto-Detect with LBA mode enabled.
INT13 Extensions and LBA mode in BIOS and FAT32 or NTFS-based
file systems are required to acheive full capacity. FAT32 file
system can create single partitions and logical drives up to 2TB.
========================
Windows XP Service Pack 1 or Windows 2000 Service Pack 3 with
48-bit LBA Address drivers are required for native support of
ATA (IDE) disc drives greater than 137GB.
Windows 98, Windows Millennium and Windows NT 4.x all have 137GB
native limitations supporting ATA (IDE) disc drives. Third-party
device drivers may be available from motherboard or host adapter
manufacturers for these legacy Windows operating systems.
Already low-level formatted at the factory.
Seagate reserves the right to change, without notice, product
offerings or specifications. (02/01/2006)
 |
|