SEAGATE TECHNOLOGY LLC
1-800-SEAGATE
http://www.seagate.com
(C)opyright 2002
ST-318452LW Ultra160 SCSI Wide (Cheetah X15 36LP, LVD)
�����������ͻ
� REAR VIEW � (ST-318452LW/LWV only)
�����������ͼ
(TOP) J5 Auxiliary
___________________ ��� �1�/���������\
�( �����������������1)ͳ::::::�� 0 0 0 0 ��
\�����������ij����/ � �� 2���5�G�G�12�
68 pin I/O Cable� ������
Connection Male ������ SCSI ID = 0 (none)
�������� SCSI ID = 1
pin-11 +5v ��ٳ������ SCSI ID = 2
pin-10 GND ���ٳ����� SCSI ID = 4
������ SCSI ID = 8
pins 9 & 12 no connection ������� or pin-8 Activity LED*
* These pins are driven low for 250ms after PWR ON and RESET
to allow jumper selectable SCSI ID as shown above.
�����������ͻ
� REAR VIEW � (ST-318452LC/LCV only)
�����������ͼ
80 pin I/O and DC Power Wall/bracket Connection
� Female
J1 /���ij���������������\ TOP (HDA)
����������/ �������������������� \����������
(\�1������������������40/) BOTTOM
Notes on 80 pin I/O connector:
pins 1 - 4 = +12v 41 - 44 = 12v GND
34 - 36 = +5v 74 - 76 = 5v GND
37 = SYNC 77 = LEDC
38 = MTRON 78 = DLYDST
39 = SCSIA0 79 = SCSIA1
40 = SCSIA2 80 = SCSIA3
Mating connector: AMP US p/n: 2-557103-1 straight-in, Male 80-pin
2-557101-1 right angle to PCB
�����������ͻ
� SIDE VIEW � (ST-318452LW/LC)
�����������ͼ
FRONT TOP (HDA) J2 87654321 �
OF ���������������������������������P�W�A�����͵J1
DRIVE BOTTOM :::::::: �;
��������
Force Single-ended (LVD models only) �ٳ������ Term Power (LW only)�
Start Delay (12 secs * ID) ��ٳ����� Reserved �
Motor Start ���ٳ���� Reserved �
Write Protect ��������� Parity Disable �
�
�
��������������������������������Ŀ �
� Termination Power-source Table ����������������
��������������������������������������Ŀ
� ....�����PWA edge����� �
� 2 1 �
� A Drive Supplies Bus �ķ �
� �� �
� (not used on LC model) ��� �
� A �
����������Default no jumper ������������
Note: LW and LC drives do not have internal terminators or
any other way of adding internal terminators to the
drive; use external active termination if required.
Use active (ANSI SCSI-2 Alternative 2) terminators
when terminating the bus. Use active negation
terminators when terminating a SCSI Ultra2 bus
operating in Low Voltage Differential (LVD) mode.
������������ͻ
� FRONT VIEW � (ST-318452LW/LC)
������������ͼ
��ĴReserved. Shipped with cover installed.
� �Do not remove. Do not install jumpers
TOP (HDA) ���� 1
��P�W�A��������������������͵::::�::::::���
* BOTTOM ����;123456
� J6 ������
LED �� ������
Remote LED ٳ���� ID 1
(pin-11 +5v) ����� ID 2
Reserved �ٳ��� ID 4
(pin-10 GND) ���� ID 8
ST-318452LW
UNFORMATTED CAPACITY (GB) ________________23.7
FORMATTED CAPACITY (GB) __________________18.35
AVERAGE SECTORS PER TRACK ________________484 rounded down
ACTUATOR TYPE ____________________________ROTARY VOICE COIL
TRACKS ___________________________________73,988
CYLINDERS ________________________________18,497 user
HEADS ______PHYSICAL______________________4
DISCS (3.0 in) ___________________________2
MEDIA TYPE _______________________________THIN FILM/GMR
RECORDING METHOD _________________________PRML 16/17 EPR4
INTERNAL TRANSFER RATE (mbits/sec)________548 to 706
INTERNAL FORMATTED TRANSFER RATE (MB/sec)_51.8 to 68.1
EXTERNAL TRANSFER RATE (mbyte/sec) _______40 Sync
Low Voltage Differential(LVD) _______80/160 Sync
SPINDLE SPEED (RPM) ______________________15k
AVERAGE LATENCY (mSEC) ___________________2.0
BUFFER ___________________________________8MB
Read Look-Ahead, Adaptive,
Multi-Segmented Cache
INTERFACE ________________________________Ultra-SCSI Wide
Low Voltage Differential __________Ultra3-SCSI Wide
ASA II, SCAM level 2 (1 default)
BYTES PER TRACK __________________________316,155
SECTORS PER DRIVE ________________________35,843,670
TPI (TRACKS PER INCH) ____________________38,000
BPI (PEAK KBITS PER INCH) ________________482
AVERAGE ACCESS (ms read/write)____________3.6/4.2
Drive level without controller overhead
SINGLE TRACK SEEK (ms read/write) ________0.4/0.8
MAX FULL SEEK (ms read/write) ____________7.0/8.0
MTBF (power-on hours) ____________________1,200,000
SHOCK (G's, 11/2/.5 ms):
operating (Read/Write) __________15
abnormal ________________________40
nonoperating ____________________75/250/100
ACOUSTICS (Bels typical, sound power) ____3.7
POWER DISSIPATION (watts/BTUs) Active ____/
Idle ______10.3/35.18
POWER REQUIREMENTS: +12V START-UP (amps) _1.44
+12V TYPICAL (amps) __0.51 idle
+5V START-UP (amps) __0.90
+5V TYPICAL (amps) ___0.83 idle
IDLE (watts) _________
LANDING ZONE (cyl) _______________________AUTO PARK
IBM AT DRIVE TYPE ________________________0 or NONE
Physical:
Height (inches/mm): 1.0/25.4
Width (inches/mm): 4.00/101.6
Depth (inches/mm): 5.75/146
Weight (lbs/kg): 1.5/0.68
Already low-level formatted at the factory with x spare sectors at
the end of each x cylinder region.
ZBR = Zone Bit Recording = Variable sectors per track
Seagate reserves the right to change, without notice, product
offerings or specifications. (08/08/2002)
|
