Barracuda (1TB/disk platform) Firmware Update

 

Firmware update information for Barracuda Serial ATA drives with the 1TB/disk platform. Check to see if your model is included.

New firmware version: CC4H


You can verify the proper firmware revision for your drive model and serial number using the Drive Detect software.

This update applies to the following models:

Model Number Part Number Capacity Firmware Downloads
ST3000DM001 9YN166 3TB CC4H in .exe format
   See Document ID: 004559 for instructions on updating your firmware in Windows using this .exe file.

CC4H in .iso format
   See Document ID: 004989 for instructions on updating your firmware in Windows using this .iso file.
   See Document ID: 004301 for instructions on updating your firmware in MacOS using this .iso file.
ST2500DM001 9YN16L 2.5TB
ST2000DM001 9YN164 2TB
ST1000DM003 9YN162 1TB

Previous versions of firmware with these models and part numbers are CC46, CC47, CC49, CC4C, or CC4G.

 If the firmware upgrade installation instructions are not followed properly, the firmware upgrade could be data destructive and/or render your hard drive inoperable. As Seagate does not warrant the data on your drive, in addition to regular back-ups, your data should be backed up, if possible, before upgrading the drive firmware. Additional information on backing up the contents of your drive can be found at our Knowledge Base. Though this firmware upgrade to your product is a change to the product, the terms and conditions of your Seagate warranty for the product will remain effective to its normal expiration. For other warranties on your product, please consult the warranty documentation provided by your supplier.